side ratio

According to the modeling result, the correlations between the main recirculation zone length and the position of side wall jet are obtained at the ratio of side wall jet velocity/ sudden-expansion inlet velocity being equal to 2.0.

根据计算结果，拟合出了当侧壁射流速度与突扩通道入口平均流速之比等于2.0时，主回流区长度与侧壁射流位置的关系式。

互联网摘选

With the decrease of aspect ratio, the temperature in tire shoulder and crown decreases obviously, and the temperature in tire side and bead hardly change.

结果还表明，轮胎胎肩、胎冠部的温度随扁平率的减小而有所降低，而胎侧、胎圈部的温度则几乎没有变化。

互联网摘选

Tension stress was introduced at the stainless steel side, and decreases with the increase of thickness ratio.

不锈钢一侧宽度方向应力为拉应力，并随着相对厚度比的增大而减小；

互联网摘选

This is largely separated into 3 sections-Gear Ratio Control, Acceleration Control, and Side Pressure Control.

这套装置大体上可分为3部分 —— 齿数比控制部分, 加速控制部分和副压力控制部分.

互联网摘选

After comprehensively surveying the minimum thermal stress, minimum ratio stress and stress state at the pure TiC side, the compositional distribution of TiC/ Ni_3Al system FGM is optimized.

在考虑热应力最小、比应力最小以及TiC侧应力状态等因素之后，对圆板状TiC／Ni3Al系梯度材料的组成分布进行了优化。

互联网摘选

When the ratio of the long side and short side increases for identical thickness of slab, the two-way effects show decrease tendency.

对同一板厚，当长边与短边比值的增大，双受力效应呈减小趋势。

互联网摘选

On the basis of the generalized steady state tire model and the theoretical equation of slip ratio, a non linear non steady state side slip tire model is proposed based on a quasi steady state concept.

在稳态指数统一模型的基础上，根据动态过程有效滑移率的理论表达式，建立了轮胎非稳态侧偏特性非线性模型。

互联网摘选

Through measuring three-phase current of low voltage at user side and handling by specific algorithm, TA ratio of HV measuring can be accurately judged whether is consistent with data plate.

通过测量用户低压侧三相电流相量，通过特定的算法处理，准确判定用户高计TA的实际变比是否与铭牌一致。

互联网摘选

The Fringe Seahorse glyph has the Fibonacci spiral on its side, the spiral itself is contained inside a visual representation of the golden ratio.

海马的身上图形是斐波纳契螺线，同时，螺线里面包含的线代表了黄金分割的比例。

互联网摘选

The results showed that side wall and axillaries angle of inverted-siphon usually under high stress, it should be enhance them. Meanwhile, seam wall usually under low stress, it could be considered to reduce the size or reinforcement ratio of the wall.

分析结果显示，管身边墙和腋角处容易产生较大应力，应考虑对其进行加强处理，缝墙的应力均处于较低状态，可考虑减小缝墙的尺寸或配筋率。

互联网摘选